The right side of my switch's screen bezel is not flush with it's housing, maybe its 1mm higher than on the left side. If you run your finger across it you notice a small bump, where as on the left side it's smooth.
Is this normal and within manufacturing acceptable tolerances or do I have a faulty Switch?
Hi
Same here. My right side is a little bit higher (0.2 mm) but only in the middle if the height. I can press it flat but it bends back after a few seconds. I think it's not a big issue
the_shpydar wrote:
As @ogo79 said, the SNS-RZ-USA is a prime giveaway that it's not a legit retail cart.
And yes, he is (usually) always right, and he is (almost) the sexiest gamer out there (not counting me) ;)
Forums
Topic: Is your screen bezel flush?
Posts 1 to 10 of 10
This topic has been archived, no further posts can be added.